Important Things to Remember in Drywall Installation
Whether you are installing drywall yourself or you want to hire a professional to do the job, there are a few important things to remember. You will want to ensure that you use the correct materials and take the necessary steps to get the job done right. If you choose to hire a professional, you should make sure that they are bonded and have a warranty. You also want to get a detailed estimate before signing a contract. This will ensure that you know what to expect before you begin.
The first step in drywall installation is to mark where the wall studs are. You will need a stud finder to find the studs. Alternatively, you can use a T-square to create a straight line in the drywall. Once you have marked the studs, you should cut a piece of drywall to fit the stud. The drywall should be cut to be a quarter inch shorter than the wall width. You can use a drywall saw or jab saw to cut the drywall sheet.
Once you have cut the drywall, you can begin putting it on the wall. You will want to make sure that it is level and flat. You will also want to ensure that it is tight against the ceiling. You may want to use a lift to help you move the drywall into place. You will also want to ensure that the drywall is at a convenient height so that you can easily drill the screws into the studs. You can also use a rotary drill to help you cut the drywall.
Once you have hung the drywall, you will want to make sure that the edges are flat. If they are not, you will need to cut them to make them level. This may also require you to sand them to get them to a smooth surface. If you do not sand them properly, the drywall will not hold well. You may also want to use mud to fill in any small holes. You can also use perforated tapes to help with this. Some contractors avoid using perforated tapes because they can cause extra mud to be needed.
You should also use coarse-threaded screws for this project. This is because coarse-threaded screws have better holding power. You should also use the spring-loaded dimpler that is used to countersink each drywall screw. This device will allow you to get the drywall screw into the stud without breaking the drywall paper.
You will want to make sure that you have a drywall saw and a drywall saw saw. These tools will help you to cut the drywall sheet to fit. You should also use a drywall knife to help apply a liberal amount of mud to the seam. It is best to apply several thin coats of mud for better results. You can also use a drywall knife to help remove excess compound.
Once you have cut the drywall, the next step in drywall installation is to drill five screws into the stud at the center of the drywall panel. You should place the screws about a foot and a half from the first row.